• tube diameter6 - 28 mm
• wall strength2 mm
• bending radius min.2 x D
• ControlIPU 20
• bending radius max.5,0 x D mm
• bending angle max.190 °
• arbor length3000 mm
• operating pressure180 bar
• hydraulic motor4 kW
• weight of the machine ca.900 kg
• dimensions of the machine ca.3,8 x 1,1 x 1,3 m

Zusatz

• Condition: ready for operation
• Video available on our website.

Zubehör

• Electric 400 Volt
• Bending segments15-20-26-28 mm
• Bending mandrels4
• Operation panel0,5 x 0,6 x 1,03 m
• Double Foot pedal
• Machine manual

Semi-automatic electro-hydr. mandrel tube bending machine with PLC control for 20 angles and display in the control panel for bending angle specification, angle detection and angle measurement via absolute value encoder, autom. tool plate reset, Turning device with digital display, hydr. quick chuck, aut. Mandrel lubrication, adjustable length stops. Operating modes: MANUAL and semi-automatic. Control buttons: hydraulics on / off, operating mode selection, clamp to / on, clamp forward / backward, mandrel forward / backward, bending forward / backward /, locking forward / backward, mandrel lubrication, turning device forward / backward, plate reset, length stop forward, emergency stop. The machine comes from a prototype construction and was only used a little until 2000. After that, the machines of this department were sold. However, the purchaser did not use the pipe bending machine and therefore it has only stood in the warehouse and has not worked since then. Please notice that the price of a new machine today is over € 60.000,--. Machine dealer with own stock of 1600 m².